Oki MC362w Maintenance Manual page 151

Oki Data CONFIDENTIAL
Item1 Item2 Item3
Password Scanner Adjust Scan
Maintenance Position
Adjust Mech.
44952001TH Rev.2
Item4 Item5 Value
ADF Side Reg. +8 ~ -8
(Front-side)
Front Edge +30 ~ -30
Back Edge +30 ~ -30
ADF Front Edge +30 ~ -30
(Back-side)
Back Edge +30 ~ -30
Adjust +30 ~ -30
ADF Scan
Position
Adjust FB FB Drive 10 ~ 1400
Motor Current
FB Keep 10 ~ 1400
Current
Adjust ADF ADF Drive 10 ~ 1400
Motor Current 1
ADF Drive 10 ~ 1400
Current 2
ADF Drive 10 ~ 1400
Current 3
Default Default Default
value value value
ODA OEL JP
0 0 0
During ADF scanning, Adjusts the scanning start pixcel position for the main
scanning direction.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 Set the CIS reading position of the ADF for the focusing standard.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm). This is correlated to adjustment
of the ADF front edge position.
300 300 300 Only for engineering test
[mA] [mA] [mA] Connect a panel or PC and set the electric current value of the scanner motor.
50 [mA] 50 [mA] 50 [mA]
800 800 800
[mA] [mA] [mA]
800 800 800
[mA] [mA] [mA]
800 800 800
[mA] [mA] [mA]
5. MAINTENANCE MENUS
Notes
5-4