Table of Contents
Advertisement
ASSEMBLY
Ensure the stapler is not loaded, then,
with the air supply turned off,
connect the air line to the stapler at
the quick fit coupling.
Turn the safety catch to the position
shown, to prevent the trigger from
being pulled.
Then with the tool pointed away from
you and anyone in the vicinity,
depress the magazine catch, pull out
the magazine and load with
appropriate staples,
Push the magazine back until it locks
in position,
Your stapler is now ready for use.
OPERATION
Turn on the air supply, and check for air leaks. If any are apparent, rectify
before proceeding. Ensure the operating pressure is set to between 4.1-6.9bar
(55-95 psi), depending upon the size of nail used and type of material being
worked. The harder the material, and bigger the nail, the higher the pressure.
Hold the tool so that it is at right angles to the work. Lower it so that the Safety
Element touches the work surface and is forced upwards. This movement
releases the trigger, which may now be pulled, driving the staple.
CLEARING A JAM
Should the stapler jam, turn OFF the air supply and set the safety catch to
prevent the trigger from being pulled before opening the magazine to free
the jammed staple.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
8
Advertisement
Table of Contents
