Related Manuals for Clarke CSA10F
Summary of Contents for Clarke CSA10F
- Page 1 10 TON HYDRAULIC PRESS Model Nos. CSA10F and CSA10B MAINTE OPERATING & MAINTENANCE INSTRUCTIONS 0200...
- Page 2 SPARE PARTS and SERVICING Please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com...
-
Page 3: Safety Precautions
The press owner and/or user must read and fully understand the operating instructions and recommendations before using this press. CLARKE International shall not be held liable to any damage to persons or equipment due to improper or non-permitted use of the press. - Page 4 • It is the owners responsibility to keep warning decals legible and intact. Replacement decals may be obtained from Clarke International Spare Parts Dep’t. • Failure to heed these warnings may result in damage to the equipment, or failure resulting in property damage, personal, or even fatal injury.
-
Page 5: Hydraulic Pump/Ram Operation
ASSEMBLY A. CSA10F Fig.1 Ensure the press and its components suffered no damage during transit. Should any damage be apparent, contact your Clarke dealer immediately. Attach the feet and foot struts to the side supports using the nuts, bolts and washers provided, leaving them finger tight. - Page 6 B. CSA10B Fig.2 Bolt the feet to the side members using the nuts bolts and washers provided. Bolt on the top and bottom plates in the manner shown in fig. 2 , ensuring the bottom plate is that with the threaded hole at its centre.
-
Page 7: Operation
OPERATION Position the bed to the desired height, so as it will be as close as possible to the ram when the workpiece is mounted. Raise one side of the bed, and insert a pin into a locating hole directly beneath the bed. -
Page 8: Maintenance
‘A’, Fig.1. Top up if necessary to the level on the dipstick, with CLARKE Hydraulic Oil, Part No. 3050830 only. - Page 9 PARTS DIAGRAM - CSA10F No. Description Qty Part No. No. Description Qty Part No. Spring Washer CSA1015 Frame CSA1001 Nut 3/8” CSA1016 Frame CSA1002 Support Plates CSA1017 Bridge CSA1003 Ram Support CSA1018 Bolt M12 CSA1004 Bolt 3/8 x 6” CSA1019...
- Page 10 PARTS DIAGRAM - CSA10B No. Description Qty Part No. No. Description Qty Part No. 10 Support Pins 2 CSA10B10 1 Frame 1 CSA10B01 11 Bed 1 CSA10B11 2 Foot 2 CSA10B02 12 Arbour Plate 1 CSA10B12 3 Bolt M10 4 CSA10B03 13 Ram Assembly 1 CSA10B13 4 Flat Washer...
-
Page 11: Specifications
SPECIFICATIONS CSA10F - Part No. 7613010 CSA10B - Part No. 7614000...
Need help?
Do you have a question about the CSA10F and is the answer not in the manual?
Questions and answers