Page 1
SIPHON FEED SANDBLASTER MODEL NO: CSB34 PART NO: 7640120 OPERATION & MAINTENANCE INSTRUCTIONS LS0513...
Page 2
INTRODUCTION Thank you for purchasing this Clarke Siphon Feed Sandblaster. Before you try to use this product, read this manual and follow the instructions carefully. In doing so you will ensure your safety and the safety of others around you. You can also look forward to a purchase that gives you long and satisfactory service.
GENERAL SAFETY RULES Warning: Compressed air can be dangerous. Ensure that you are thoroughly familiar with all precautions relating to the use of compressors and compressed air supplies. 1. Read this instruction manual before connecting the sandblaster to a compressor. 2.
Page 4
UNPACKING Unpack your sand blaster and its accessories and make sure that the following items are present. Should there be any damage caused during transit contact your Clarke dealer immediately. Upper Frame (HTCSB3403) Sandblasting Gun (HTCSB3402) Ceramic nozzles Drum Assembly...
Page 5
ASSEMBLY Slide the axle through the upper frame and lower frame as shown Upper Frame on the right. Axle Lower Frame Slide the spacer (5) onto the axle Wheel Washer followed by the wheel, then the thin washer (6), and secure in place using the split pin (2).
Page 6
5. Fit the leg/prop stand to the drum and secure in place using 2 short bolts (1), 4 washers (3) and 2 nuts (7). 6. Secure in leg/prop stand to the lower frame using the long bolt (9), 2 washer (3) and 1 nut (7). 7.
OPERATION USING YOUR SANDBLASTER Connect your sandblasting gun to a compressor (minimum 3hp capable of supplying a minimum of 10 CFM of air) via the 3/8” hose adaptor located at the base of the handle. Set the working pressure on your air compressor to 6 - 8 bar (87 - 116 psi). 1.
• Replace any parts which appear worn. PARTS AND SERVICING For Parts & Servicing, please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 or e-mail as follows: PARTS: Parts@clarkeinternational.com...