Teldat REGESTA 1 Installation And Configuration Manual page 34

4 Configuration
Description
Example
Syntax
Description
Example
Syntax
Description
Example
Syntax
Description
Example
Syntax
Description
Example
30
This command allows you to configure the mask to limit the IP addresses that may
establish a data connection with the device.
This command is only valid if the "AT*Z17=0" command indicates server mode.
This command format is similar to an IP address. In this case the IP address for
the incoming TCP/IP session is "filtered" with this mask and if it doesn't pass the
filter, the connection is dropped.
AT*Z12="255.255.255.255"
OK
AT*Z13=<prot_type>
Allows you to configure the type of protocol to use in the data connections.
<prot_type> can take the following values:
0 TCP connection.
1 UDP connection.
AT*Z13=0
OK
AT*Z14=<port >
This command allows you to configure the number of the port that listens to the
TCP/UDP connection petitions, over which the data connection is established.
This command is only valid if the "AT*Z17=0" command indicates server mode.
<port> this can take values between 1 and 65535.
AT*Z14=4500
OK
AT*Z15=<num >
This command allows you to configure the number of connection retries.
This command is only valid if the "AT*Z17=1" command indicates client mode.
<num> this can take values between 0 and 10.
AT*Z15=2
OK
AT*Z16=<time >
This command allows you to configure the time between connection retries.
This command is only valid if the "AT*Z17=1" command indicates client mode.
<num> this can take values between 3 and 500 seconds.
AT*Z16=2
OK
Teldat S.A.
REGESTA 1