Slip Mode - Teldat REGESTA 1 Installation And Configuration Manual

Teldat S.A.
Socket 3 - COM spy:..DISCONNECTED
Socket 4 - GPRS spy:.DISCONNECTED
Socket 5 - :.........CLOSED
COM STATUS
State:.....OPEN
Mode:......COMMAND
TX bytes:..0
RX bytes:..15
SNMP STATUS
State:.....STOP
GSM/GPRS STATUS
IMEI: 357251010290987
IMSI: 214072530000435
GSM FW rel.: 07.03.940
Current mode: GPRS
State: GSM/GPRS module connected
APN: movistar.es
IP Address: 88.28.155.131
Connection uptime: 24 secs
#MONI: Cell
#MONI: S
#MONI: N1
#MONI: N2
#MONI: N3
#MONI: N4
#MONI: N5
#MONI: N6
OK
To exit enter the ATO or the AT*ZEXIT command:
ato
OK
Caution
Executing the ATO or AT*ZEXIT command can force the device to restore a GPRS or DATA connec-
tion. This happens when a parameter has been modified in the commands phase and this process
needs to be executed to activate the new configuration.

4.2.2 SLIP Mode

When the device starts up in SLIP mode, the behavior is different to starting up in IEC or TRANSPARENT modes. In
SIP mode, the device immediately starts up in the AT commands and remains in commands mode for 120 seconds
or until the ATO command is entered. Each time you enter a valid AT command (the device must return an OK) the
counter for 120 seconds restarts.
Teldat REGESTA 1 (c)2009
GSM/GPRS ROUTER Release 1.2
SCADA IEC-101/102 gateway
REGESTA 1
BSIC LAC CellId ARFCN
52 0B05 082C 15
52 0B05 0123 52
60 0B05 082F 523
52 0B05 082B 48
60 0B05 0000 517
60 0B05 0000 528
60 0B05 0000 512
Power C1 C2 TA RxQual
-56dbm 46 46 0 0
-62dbm 40 32
-64dbm 38 30
-70dbm 32 24
-73dbm 29 37
-79dbm 23 15
-81dbm 21 13
PLMN
MOVISTAR
4 Configuration
15