Table of Contents
Advertisement
Main Power Select (
The main power select jumper selects whether the main power source for the board is provided from the USB or an
the optional 5V external source through the connector X401. The default setting is USB.
Table 3-12:
Main Power Select Jumper
Position
1 and 2
2 and 3
Power (
)
LED1
When ON (green), it indicates that power is being supplied to the board properly.
Reset (
)
LED4
When ON (red), it indicates that the board is in reset. A master reset is asserted by pressing
activates the LED. For more information, see
Fault (
)
LED5
When ON, it indicates a system fault. For more information, refer to the ADSP-CM41x Mixed-Signal Control
Processor Hardware Reference.
)
JP200
Power Source
USB
5V Input X401 connector
Reset
Pushbutton.
25
which
RES switch,
Advertisement
Table of Contents
