Table of Contents
Advertisement
2-D LiDAR Sensor
Maintenance and Repair
7
Maintenance and Repair
7.1
Maintenance
Caution!
Failure to clean and improper cleaning may cause property damage and
malfunction
Failure to follow these instructions for cleaning the device may result in lens
damage and impaired function.
Keep the glass on the device clean.
Never clean the glass on the device when the glass is dry. Always use a soft cloth
and water, with a little detergent if necessary.
Do not use aggressive solvent-based cleaning agents such as acetone.
Observe the applicable national regulations when maintaining the device.
The sensor is largely maintenance free.
Check the technical safety of the sensor system at regular intervals by looking for
damage to the housing. Check the sensor for dirt occasionally.
To clean the sensor, wipe it with a damp soft cloth at regular intervals. This will
ensure it continues to function properly. The housing is made of plastic. For this
reason, do not use acetone or detergents containing solvents.
7.2
Repairs
If it appears that safe operation of the system is no longer possible, the system
must be taken out of operation and steps taken to prevent it being used
inadvertently. If the device needs to be repaired, return it to Pepperl+Fuchs. If you
open or modify the device yourself, not only are you endangering yourself and
others but you will void any warranty and absolve the manufacturer from any
liability.
30
Advertisement
Table of Contents
