Damages Of Suction Plate; Protective Equipment; Behaviour In Emergencies; Checking The Safety Devices - probst SH-1000-MINI Operating Instructions Manual

Safety
2.7

Damages of suction plate

Avoidance of damages:
•
To avoid damages of the rubber seal on the suction plate (chinks, abrasion) take notice, that:
•
during the operation (lifting, transporting and lowering) with the device, the suction plate does not
brush or pump against other products or materials.
•
Otherwise the rubber seal on the suction plate could be damaged (danger of pressure loss).
Load could fall down. Danger of accidents!
2.8

Protective equipment

The protective equipment must consist, according to the safety regulations
of the following parts:
2.9

Behaviour in Emergencies

An emergency situation exists when
•
power suddenly fails (device switches off),
•
the vacuum pressure drops below -0.6 bar to the red section on the scale of the vacuum gauge.
Lower the load immediately if possible. If this is not possible, immediately leave the dangerous area near
the load, since it will be dropped from the device.

2.10 Checking the Safety Devices

The lifting device is equipped with
following safety devices:
5240.0020
•
vacuum gauge with red danger zone
•
warning device, audible (optional)
•
Check these devices at the beginning of each shift (when operating in shifts)
or once a week (when operating continually).
V4
10 / 34
•
Protective clothing
•
Safety gloves
•
Safety shoes
•
Hearing protector
GB