Lowering; Lifting Wet Loads - probst SH-1000-MINI Operating Instructions Manual

Operating
5.2.2

Lowering:

•
Lower the load to a safe and clear, level surface, to ensure that the load cannot slip or tip over.
•
Shift the bushing on the slide valve back. The load is released.
5.2.3

Lifting wet loads

•
The lifting device is not intended for picking up wet stone slabs. When picking up wet stone slabs, please
observe the following:
•
Remove water from the suction surface.
•
Carry out the following points after working with damp parts:
•
Lift up the lifting device. Make sure that the area around the suction plate is clear and that no items or water
can be drawn in.
•
Let the pump idle to run dry for at least 5 minutes.
•
Then switch off the device.
•
•
Then switch off the device.
•
Open the condensate drain screw on the bottom of the storage container. Drain the water completely and
tighten the drain screw securely.
•
5240.0020 V4
•
Fig.- A
25 / 34
GB