Inspecting The Vacuum Hoses And Hose Clamps; Testing The Vacuum Reservoir; Damages Of Suction Plate; Protective Equipment - probst QUICKJET QJ-600-E Operating Instructions Manual

Safety
2.11

Inspecting the vacuum hoses and hose clamps

•
Check that all vacuum hoses and hose clamps are securely seated. Tighten any loose
connections.
2.11.1

Testing the vacuum reservoir

•
See the sub-section "Leak test" in the section "Maintenance"
•
Rectify any detected faults before using the lifting device. If a fault becomes apparent during,
switch off the lifting device and rectify the fault.
2.12

Damages of suction plate

Avoidance of damages:
•
To avoid damages of the rubber seal on the suction plate (chinks, abrasion) take notice, that:
•
during the operation (lifting, transporting and lowering) with the device, the suction plate does not
brush or pump against other products or materials.
•
Otherwise the rubber seal on the suction plate could be damaged (danger of pressure loss).
Load could fall down. Danger of accidents!
2.13

Protective equipment

The protective equipment must consist, according to the safety regulations
of the following parts:
52400045 / 52400049 10 / 29
•
Protective clothing
•
Safety gloves
•
Safety shoes
•
Hearing protector
GB