Connecting To A Power Supply - Christie APS Series Setup Manual

Connecting to a power supply

1.
Put the connector of the power cord into the
AC (AC inlet) of the product.
2.
Firmly plug the power cord's plug into the outlet.
In a couple of seconds after the power supply
connection, the POWER/STATUS indicator
lights up in steady orange.
When the DIRECT POWER ON function is
activated, the connection of the power supply
make the projector turn on.
When the AUTO POWER ON function is activated
and the projector is receiving an input signal, it is
turned on by connecting to the power supply.
3.
Use the supplied cable tie (for power cord) to
fasten the power cord.
►Use extra caution when connecting the power cord, as incorrect or faulty
connections may result in fi re and/or electrical shock.
- Do not touch the power cord with a wet hand.
- Only use the power cord that came with the projector. If it is damaged,
consult your dealer to get a new one. Never modify the power cord.
- Only plug the power cord into an outlet whose voltage is matched to the
power cord. The power outlet should be close to the projector and easily
accessible. Remove the power cord for complete separation.
- Do not distribute the power supply to multiple devices.
overload the outlet and connectors, loosen the connection, or result in fi re,
electric shock or other accidents.
- Connect the ground terminal for the AC inlet of this unit to the ground
terminal of the building using an appropriate power cord (bundled).
►This product is also designed for IT power systems with a phase-to-phase
voltage of 220 to 240 V.
LWU650-APS/LWU530-APS
Setup Guide
Cable tie for power cord
WARNING
NOTICE
12
POWER/STATUS
indicator
Doing so may
020-001521-02 Rev. 1 (01-2019)
LIT GUID SET APS Series
AC
Power
cord