Inserting Or Replacing The Internal Clock Battery - Christie APS Series Setup Manual

Inserting or replacing the internal clock battery

This product has an internal clock. The battery for the internal clock is not
contained at the time of factory shipment. When you use the function that requires
the internal clock ("Event Scheduling" in the Network Guide), install a new
battery according to the following procedure.
Use the following type of battery.
MAXELL, Part No. CR2032 or CR2032H
1.
Turn the projector off , and unplug the power cord.
Allow the projector to cool suffi ciently.
2.
Turn the battery cover fully counterclockwise using a
coin or the like, and pick the cover up to remove it.
3.
Pry up the old battery using a fl athead screwdriver or
the like to take it out. Do not use any metal tools. While
prying it up, put a fi nger lightly on the battery since it
may pop out of the holder.
4.
Insert the new battery or replace the battery with a new
one.
Slide the battery in under the plastic claw, and push it
into the holder until it clicks.
5.
Place the battery cover in place, then turn it clockwise
using such as coins to fi x.
►Always handle the batteries with care and use them only as
battery may explode if mistreated. Do not recharge, disassemble or dispose of
using fi re. Improper use may result in cracking or leakage, which could result
in fi re, injury and/or pollution of the surrounding environment
- Be sure to use only the batteries specifi ed.
- Make sure the plus and minus terminals are correctly aligned when loading
a battery.
- Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
- Do not short circuit or solder a battery.
- Do not place a battery in fi re or water. Keep batteries in a dark, cool and dry
place.
- If you observe battery leakage, wipe out the leakage and then
battery. If the leakage adheres to your body or clothes, rinse well with water
immediately.
- Obey the local laws on disposing a battery.
LWU650-APS/LWU530-APS
Setup Guide
WARNING
19
Battery Cover
90°
90°
directed. The
replace a
020-001521-02 Rev. 1 (01-2019)
LIT GUID SET APS Series