Charge The Battery - ASCOM 9d24 Mkll User Manual

Hide thumbs Also See for 9d24 Mkll:

Table of Contents

User Manual

9d24 Mkll Cordless Telephone

The document above and the EC Declaration of Conformity can be found at http://

www.ascom.com/ws/solutions_ws/products_ws.htm and http://www.iecex.com

11.2 Charge the Battery

The battery requires charging when the battery icon in the handsets display is empty.

Place the handset in the charger. A beep indicates connection with the charger. The

charging status is shown by the battery icon in the handset display. After approximately

two (Desktop Charger) / four (Charging Rack) hours the handset is fully charged,

indicated by a filled battery icon.

If the handset is switched off automatically due to low battery and placed in a charger the

handset will be switched off but charged. The charging starts within 5 seconds. To start

the handset press and hold the Call key

Press "Yes" within 10 seconds.

If a call is connected when the handset is placed in the charger the handset will be

charged and fully operational at the same time.

Note: Charging below 0°C will harm the battery and shorten the lifetime.

Note: The handset can be charged in the wall-mounted Charging Rack without removing

the pull-cord catch.

Note: When charging an EX-version the Desktop Charger must be marked with DC2 and

the Charging Rack must be marked with CR2.

IMPORTANT: Charging of 9d24 MkII EX-Messenger and 9d24 MkII EX-Protector is NOT

2007-02-07/ Ver. D

permitted in hazardous area.

; the question "Switch on?" will be displayed.

TD 92333GB

Table of Contents

Do you have a question about the 9d24 Mkll and is the answer not in the manual?