Connection Method Speech Monitoring; Connection Method Loud; Connection Method Ordinary; Alarm Management With Automatic Calls - ASCOM 9d24 Mkll User Manual

User Manual
9d24 Mkll Cordless Telephone
of handsets. The handset can be configured to call the same number for all types of
alarms or to call different numbers depending on the alarm type.
A Hot key in the handset automatically is triggered when an alarm is activated.The
specific Hot key must be programmed to dial the phone number, see
on page 40.
This is a system dependent function that also require a SIM card parameter setting in the
handset.
Note: An ongoing call will be disconnected, unless it is an alarm call, when the alarm is
transmitted. Then the telephone number associated with the alarm will be dialled.
Note: If the function automatic call after an alarm is combined with the ALS function the
speech will be muted in both directions. If the ALS is timed out during the call speech
monitoring functionality will be activated. If the ALS is muted with the mute button the
call will change into ordinary mode.
5.9.1

Connection method Speech Monitoring

Speech monitoring is the default connection method for an automatic call after an alarm.
The microphone on the handset that sends the alarm is discreetly activated in a highly
sensitive mode and the speaker is muted. This will give the answering party opportunity
to listen and to take an appropriate decision on how to act.
Areas of use are people working alone within fields like treatment of offenders, social
work, medical care and psychiatry. It provides a high level of security and opportunity to
survey the situation at the alarm site.
5.9.2

Connection method Loud

Changing the SIM parameter Call after alarm connection method will allow the
automatic call after an alarm to be connected with loudspeaking function turned on.
5.9.3

Connection method Ordinary

Changing the SIM parameter Call after alarm connection method will allow the
automatic call after an alarm to be connected in an ordinary way.

5.10 Alarm Management with Automatic Calls

In systems where messaging cannot be used for alarm transmission, automatic calls after
alarm can be used to send the alarms to the system. In this case, the SIM parameter
should be set so that Hot key 6 to 9 are associated with the different types of alarms.
Note: In these systems, the call will be disconnected automatically.
2007-02-07/ Ver. D
TD 92333GB
8.5.9 Edit a Hot key
25