Teledyne Meridian User Manual page 8

MERIDIAN
UNIVERSAL GAS DETECTOR
TABLE OF CONTENTS
Table of Contents (Continued)
Sect. # Section Title
4.1.18. Connecting a Device to a Power Supply & Receiver: 3-wire
4.1.19. Connecting a Device to a Power Supply: 2-wire
4.1.20. Connecting a Device to a Power Supply & Receiver: 4-wire
4.1.21. Connecting a Device to Other Teledyne DETCON Receivers
4.1.22. Connecting Optional Relays & Remote Alarm Reset
4.1.23. Connecting the Optional MODBUS RS-485
4.1.24. Installing the Optional Communication Expansion Card (CEC) PCB
4.1.25. Connecting a Sensor Head
4.1.26. Installing/Replacing a Sensor
5. Configuration & Setup
5.1. Configuring the Device
5.1.1. User Access Levels
5.1.2. Using the Information Menu
5.1.3. Configuring the Setup Menu
5.1.4. Configuring the Calibration Menu
5.1.5. Configuring the Datalog Menu
5.1.6. Configuring the Display Menu
5.1.7. Configuring the User Access Menu
5.2. Device Configuration Examples
5.3. Configuration Defaults
5.4. Using the MODBUS Registers
5.4.1. MODBUS Message Framing
5.5. Using the TXCommands
6. Operation
6.1 Operating the Device
6.1.1. Powering Up
6.1.2. Powering Down
7. Maintenance
Information contained herein is classified as EAR99 under the U.S. Export Administration Regulations. Export, reexport or diversion contrary to U. S. law is
vi
USE AND DISCLOSURE OF DATA
prohibited.
Page #
4-28
4-31
4-33
4-37
4-37
4-39
4-41
4-42
4-44
5-1
5-1
5-2
5-5
5-9
5-17
5-18
5-21
5-22
5-23
5-30
5-32
5-53
5-55
6-1
6-1
6-6
6-6
7-1