Sofar solar HYD 10K-20KTL-3PH User Manual page 8

Danger
Warning
Attention
Note
Operation
Danger
Attention
Maintenance and repair
Danger
Attention
EMC / noise level of inverter
HYD 10-20KTL-3PH
Before the electrical connection, make sure to use opaque
material to cover the PV modules or to disconnect PV array DC
switch. Exposure to the sun, PV array will produce a dangerous
voltage!
All installation accomplished only by professional electrical
engineer!
Must be trained;
Completely read the manual operation and understand
relevant matter.
Get permission from the local electrical gird operator,
complete all electrical connections by professional electrical
engineer, then connect inverter to electrical grid.
It's forbidden to remove the tamper evident label, or open the
inverter. Otherwise Sofarsolar will not provide warranty or
maintenance!
Touching the electrical grid or the terminal of the equipment
may lead to electrocution or fire!
Don't touch the terminal or conductor connected to the
electrical grid.
Pay attention to any instructions or safety documents related to
grid connection.
Some internal components will be very hot when inverter is
working. Please wear protective gloves!
Before any repair work, turn OFF the AC circuit breaker
between the inverter and electrical grid first, then turn OFF the DC
switch.
After turning OFF the AC circuit breaker and DC switch, wait
for 5 minutes at least before carrying out any maintenance or repair
work.
Inverter should work again after removing any faults. If you
need any repair work, please contact with the local authorized
service center.
Can't open the internal components of inverter without
authorized. Shenzhen SOFARSOLAR Co., Ltd. does not take any
responsibility for the losses from that.
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 3 -
User manual