Provision ISR ZP-20A-2(IR) User Manual page 17

2) <SET>: Move the cursor here and press IRIS OPEN to enter. Move the
dome to a defined position as a preset point and press IRIS OPEN to save
the preset position.
3) CALL: Move the cursor here and press IRIS OPEN to call up the current
preset.
4) DELETE: Move the cursor here and press IRIS OPEN to delete the current
preset.
5) SPEED: Move the cursor here and press IRIS OPEN to set up the preset
call-up speed of LOW, MID and HIGH.
4.3.4.2 SCAN
SCAN NO:001
START
(LEFT LIMIT)
(RIGHT LIMIT)
SCAN SPEED:10
BACK
The dome supports 8 groups of auto scan. Please check the following
steps to set up a scan.
1)SCAN NO.: Move the cursor here and press IRIS OPEN to enter the setup of
SCAN Number. Move the joystick to select a preset number (1-8) and press
IRIS OPEN to confirm.
2)TITLE: Move the cursor here and press IRIS OPEN to enter the setup of
SCAN Title. Check the detailed above in DOME TITLE settings.
3)<LEFT LIMIT>: Move the cursor here and press IRIS OPEN to enter. Move
the dome to a defined position as the left limit and press IRIS OPEN to save
SCAN
EXIT
16