Extron electronics DMP Plus Series Configuration Manual page 27

DMP Plus Series C V / C V AT – Patton POTS
method 1 local
method 2 none
context ip router
interface eth0
ipaddress 192.168.1.253 255.255.255.0
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
context ip router
route 0.0.0.0 0.0.0.0 192.168.1.1 1
context cs switch
no digit-collection timeout
routing-table called-e164 RT_from_FXO_00
route default dest-interface IF_SIP MAP1001
routing-table called-e164 RT_from_FXO_01
route default dest-interface IF_SIP MAP1002
mapping-table called-e164 to called-e164 MAP1001
map default to 1001
mapping-table called-e164 to called-e164 MAP1002
map default to 1002
interface sip IF_SIP
bind context sip-gateway GW_SIP
route call dest-service FXO-HUNT-OUT
remote 192.168.1.254
early-connect
interface fxo IF_FXO_00
route call dest-table RT_from_FXO_00
disconnect-signal loop-break
ring-number on-caller-id
dial-after dial-tone
interface fxo IF_FXO_01
route call dest-table RT_from_FXO_01
disconnect-signal loop-break
ring-number on-caller-id
dial-after dial-tone
service hunt-group FXO-HUNT-OUT
drop-cause normal-unspecified
drop-cause no-circuit-channel-available
drop-cause network-out-of-order
drop-cause temporary-failure
drop-cause switching-equipment-congestion
drop-cause access-info-discarded
drop-cause circuit-channel-not-available
drop-cause resources-unavailable
Revision Date:
10/16/2020
Page 27 of 28