Extron electronics DMP Plus Series Configuration Manual page 8

DMP Plus Series C V / C V AT – Patton POTS
• Using Extron DataViewer
o Download the attached file "DataViewer Set Patton IP address.txt" from the PDF
 Refer to
o Open Extron
Click Connect from the toolbar
o
 File -> Connect (ALT+E)
o Select the RS-232 Tab
 Setup the port:
o Press OK/Enter until you see "login:"
• Once connected to the Patton and you see login:
• In DataViewer select "Run Script from the menu bar
o Tools -> Send Script File ( ALT + F )
o Select DataViewer Set Patton IP address.txt and Click Open
 Refer to
• The Script will set the IP address to
o 192.168.1.253 / 255.255.255.0
connect to the Patton POTS interface via RS-232
Appendix A to download the files from the PDF
DataViewer
• Com Port (select COM port on your computer)
• Baud Rate: 9600
• Parity Bit: None
• Data Bit: 8
• Stop Bit: 1
• Handshake: None
Appendix A to download the files from the PDF
Revision Date:
10/16/2020
Page 8 of 28