Cleaning And Care - Vitek VT-8238 VT Manual Instruction

•
Install one of the attachments (7), (8)
or (9). To do this insert the attachment
into the hot air styler body (6) and turn it
clockwise. If the attachment is set prop-
erly, you will hear the lock button (1)
«►» click.
•
Before switching the unit on, make
sure that your home mains voltage
corresponds to the unit operating
voltage.
•
Make sure that the operation mode
switch (3) is set to the position "0".
•
Insert the power plug into the mains
socket.
•
Set the required settings of the air flow
using the switch (3):
«0» – the hot air styler is switched off;
«1» – low speed and low temperature;
«2» – high speed and high temperature.
•
The cool shot mode is switched on with
the button (2)
mode on press and hold down the but-
ton (2). To switch cool shot mode off
release the button (2).
•
When the unit is switched on (the
switch (3) is in the position «1», «2»),
the indicator (4) lights up; when the
unit is switched off, the indicator (4)
goes out.
Note: During the first operation some
foreign smell and a small amount of smoke
from the heating element is possible, it
is normal.
•
After the hot air styler operation is fin-
ished, switch it off by setting the switch
(3) to the «0» position and unplug it.
•
Wait till the hot air styler cools down.
•
To remove the attachment, press the
attachment release button (1) «►» and
turn the attachment counterclockwise.
Overheating protection
Overheating protection switches the hot
air styler off if the outgoing air is too hot.
If the hot air styler is switched off during
M VT-8238.indd 5
. To switch cool shot
5
operation, set the switch (3) to the «0»
position, unplug the unit and make sure
that the inlets and outlets are unblocked.
Let the unit cool down for 5-10 minutes
and switch it on again. Do not block the
air inlets during unit operation and avoid
getting of hair into its air inlet (4).

CLEANING AND CARE

The hairdryer is intended for household
use only.
•
Set the switch (3) to the «0» position,
disconnect the hot air styler from the
mains and let it cool down.
•
To remove the attachment, press the
attachment release button (1) «►» and
turn the attachment counterclockwise.
•
Wipe the unit body (6) with a damp cloth
and then wipe it dry.
•
Clean the air inlet grid (4).
•
Never immerse the unit into water or
other liquids.
•
Do not use abrasives and solvents to
clean the unit body.
STORAGE
•
Disconnect the unit from the mains and
clean it.
•
Never wind the power cord around
the hot air styler, as this can dam-
age the cord or the unit body. Handle
the power cord with care, do not pull,
twist or stretch it, especially near the
power plug or at the junction point.
Straighten the cord periodically if it
gets twisted during the hot air styler
operation.
•
For easy use of the hot air styler, it has
a hanging loop (5) you can hang the
unit on, provided that no water gets
on the unit.
•
Use the pouch (10) for storage of the
unit and the attachments.
•
Keep the unit away from children in a
dry cool place.
ENGLISH
23.01.2017 11:40:43