Safety Measures - Vitek VT-8238 VT Manual Instruction

HOT AIR STYLER VT-8238 VT
The hot air styler is used for styling dry or
slightly wet hair.
Distinctive features of this model are the
concentrated air stream brush, the thermo
brush 40 mm in diameter, and the grid
coating made with the Tourmaline Ionic +
Ceramic coating technology.
The concentrated air stream thermo
brush:
–
provides even hot air stream spread
over the full surface of a lock of hair;
–
unlike normal flat brushes, the brush has
no large holes as to prevent loss of hot air;
–
ensures better brushing of hair of any
length.
DESCRIPTION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
ATTENTION!
•
Do not use the unit near containers
filled with water (such as bath, swim-
ming pool etc.) and in rooms with high
humidity.
•
After using the unit in a bathroom,
unplug it by taking the power plug out
of the mains socket, as closeness of
water is dangerous even if the unit is
switched off.
•
For additional protection you may install
a residual current device (RCD) with
nominal operation current not exceed-
ing 30 mA into the bathroom mains;
contact a specialist for installation.
M VT-8238.indd 3
Attachment release button «►»
Cool shot on button
Operation mode switch (0-1-2)
Air inlet grid
Hanging loop
Body
Nozzle attachment
Thermo brush Ø = 30 mm
Concentrated air stream brush
Pouch

SAFETY MEASURES

Before using the unit, read this manual
carefully and keep it for future reference.
Use the unit for intended purposes only,
as specified in this manual. Mishandling
the unit can lead to its breakage and
cause harm to the user or damage to his/
her property.
•
Before switching the hot air styler on,
make sure that your home mains volt-
age corresponds to the unit operating
voltage.
•
To avoid fire, do not use adapters for
connecting the unit to the mains.
•
Use only the attachments supplied.
•
When using the unit, we recommend to
unwind the power cord to its full length.
•
The power cord may not:
–
touch hot objects,
–
run over sharp edges,
–
be used for carrying the unit.
•
Check the power cord and power plug
insulation integrity periodically.
•
Do not switch the unit on in places
where aerosols are sprayed or highly
flammable liquids are used.
•
Hair spray shall be applied only after
hair styling is finished.
•
Do not operate the unit while taking
a bath.
•
Never leave the operating unit unat-
tended.
•
Do not touch the unit body, the power
cord and power plug with wet hands.
•
Do not place and do not keep the unit
in places, where it can fall into a bath or
a sink filled with water, do not immerse
the unit into water or other liquids.
•
If the unit is dropped into water, unplug
it immediately, and only then take it out
of the water.
•
Do not use the unit when you are
drowsy.
•
Do not use the unit to style wet hair or
synthetic wigs.
3
ENGLISH
23.01.2017 11:40:43