Bosch KTS 200 Operating Instructions Manual page 23

8. Switch on the KTS 200.
i
The ESI[tronic] Startcenter installation routine
automat-ically installs the USB driver to permit com-
munication between the KTS 200 and the PC/laptop.
The dialog "USB connection" does not appear if the
USB driver has already been installed on previous
Startcenter installation (e.g. for KTS 340) or if the
operating system Win 7 (64-bit) is available on the
PC/Laptop.
 The following message appears with Win XP:
This wizard helps you install soft-
ware for: KTS-embedded.
Robert Bosch GmbH
Initial startup | KTS ��� | ��
 The following message appears with Win 7
(32 bit):
Windows needs to install driver soft-
ware for your KTS embedded.
9. Close the message with "Cancel".
 The following message then appears with Win-
Windows can't verify the pu-
dows Vista:
blisher of this driver software.
10. Confirm the message with "Install this driver soft-
ware anyway".
11. Restart the PC/Laptop to successfully conclude
installation.
12. Disconnect the power supply unit and the USB
connecting cable at the KTS 200.
KTS ��� | �� | �� en
|
1 689 989 001 2012-03-16