UTC Fire and Security Det-Tronics X2200 Instructions Manual page 20

Uv flame detector

Table of Contents

CERTIFICATION—

F M

APPROVED

For complete FM certification details, refer to Appendix A.

For complete CSA certification details, refer to Appendix B.

For complete ATEX/CE certification details, refer to Appendix C.

Operational performance verified from –40°C to +75°C.

An optional third party addressable module can

only be used within the Ex d flameproof model

unless the addressable module is component

certified as Ex e for use within the Ex d e increased

safety model.

Refer to "EOL Resistors" section for installation

details. All cable entry devices and blanking

elements shall be certified to "E-generation" or

"ATEX" standards, in type of explosion protection

increased safety "e" or flameproof enclosure "d" (as

applicable), suitable for the conditions of use and

correctly installed. They shall maintain the degree

of ingress protection IP66 for the apparatus.

Unused apertures shall be closed with suitable

blanking elements.

For ATEX installations, the X2200 detector housing

must be electrically connected to earth ground.

8.3

NOTE

For complete IECEx certification details, refer to Appendix D.

VdS

Performance per EN54-10,

Certificate of Approval G-203083.

EC-Certificate of Conformity

08 0786 – CPD – 20777

EN54-10 Flame detectors - Point detectors.

For complete VdS certification details, refer to Appendix E.

95-8549

Table of Contents