Reset Button; Rebooting The Device; Default Configuration - Teldat H2 Installation Manual

Teldat S.A.
Protection Fuse
Fig. 10:
If the device is not operating, please check that the fuse is correctly installed and has not blown.
Warning
The fuse must have the characteristics indicated by Teldat S.A..

3.5 RESET button

The Teldat H2 Automotive has a button labeled RESET on the rear panel of the device. This button is physically
protected to stop it from being accidentally pressed.To activate it, please use a sharp pointed object.
The features of the reset button are described below.

3.5.1 Rebooting the device

If you press the RST button once the device is running normally, it will restart.

3.5.2 Default configuration

The RST button allows you to reboot the device to its factory default settings by following these steps:
• With the device switched off, press and hold down the RST button and switch on the router using the ON/OFF
switch (1).
• Stop pressing the RST button after 5 seconds.
The router's default configuration establishes the following IP address and mask:
• IP address: 192.168.1.1
Teldat H2 Automotive Router
3 Components and Power Supply
13