Table of Contents
Advertisement
RollCall Control Panel
RollTrack
RollTrack
The RollTrack page allows information to be sent, via the RollCall network, to other compatible
units connected on the same network.
The Source window lists the RollTrack sources:
Source Pane
Disable All
When checked, all RollTrack items are disabled.
RollTrack Index
This slider allows up to 16 distinct RollTrack outputs to be set up. Dragging the slider selects the
RollTrack Index number, displayed below the slider. Clicking P selects the default preset value.
RollTrack Source
The source of information that triggers transmission of data is selected with this control.
Dragging the slider selects the RollTrack source, displayed below the slider. Clicking P selects
the default preset value. When no source is selected, Unused is displayed.
RollTrack Source
Unused
Input N OK
Input N LOST
Where N is the input number
RollTrack Address
This item enables the address of the selected destination unit to be set.
The address may be changed by typing the new destination into the text field, then clicking S
to save the selection. Clicking P returns to the default preset destination.
The RollTrack address consists of four sets of numbers, for example, 0000:10:01*99:
88
• The first set, 0000, is the network segment code number.
• The second set, 10, is the number identifying the (enclosure/mainframe) unit.
• The third set, 01, is the slot number in the unit
• The fourth set, 99, is a user-definable number that is a unique identifier for the destination
unit in a multi-unit system. This ensures that only the correct unit will respond to the
command. If left at 00, an incorrectly fitted unit may respond inappropriately.
Description
No RollTracks sent.
Input N is good.
Input N is bad.
Advertisement
Table of Contents
