Table of Contents
Advertisement
Option
PTP Network Interface
PTP Configuration
PTP Status
Save Settings
PTP Status Details
When the PTP Status Details check box is enabled, the following information is displayed:
Interface Status
Displays which port is being used for local clock correction. Click Next Interface to move
between available PTP Network interfaces.
Interface Status pane
Operation
Allows selection of the interface which is to support PTP.
Enable check boxes as required.
• The Preference list allows port priority to be set. Select
from:
• None - PTP will fail over from one to the next in the
absence of sync messages. Once failed over, it shall
remain on that port until it fails over again.
• Ethernet 1 - If Ethernet 1 is available, it has priority. Thus,
if we have failed from Ethernet 1 to Ethernet 2, as soon as
Ethernet 1 becomes available again we will switch back.
• Ethernet 2 - as per Ethernet 1 but for Ethernet 2.
Select values from the PTP Domain and PTP Delay Request
Frequency drop-down lists, as required. Type the
appropriate IP number into the PTP Multicast address field.
Displays PTP status information. Enable the Details check
box to display detailed interface status information, reset
counters, show details for other PTP interfaces etc. See
Status
Details, below, for more information.
Displayed only if settings on this page are changed. Clicking
Restore will discard the changes, while clicking Restart will
implement the changes and reboot the module.
IQMIX25/40
User Manual
PTP
39
Advertisement
Table of Contents
