Ethernet Pages 1 and 2
The Ethernet pages show details and status for each network interface. The IQMIX defaults to
use of DHCP, but this can be overridden and a static IP address defined if required.
Ethernet 1 Page
The Ethernet Pane
The Ethernet pane displays details of the currently selected network interface, and allows a
static IP address to be defined. Enter information as required, enable the Static radio button,
then click S to save. New settings are applied when Restart is clicked.
Where Am I? Checkbox
When enabled, the Where Am I function causes the SFP/QSFP LEDs for the relevant Ethernet
connector to flash, allowing the module to be physically located.
Clear Link Change Count
Click to reset the Link Change counter to zero.
The Switch LLDP Info Pane
This area displays information about the Ethernet switch that the port is connected to.
The All Traffic/CPU Traffic Panes
Click the Enable Stats check box to display information on traffic through the module.
Note: Ethernet pages 1 & 2 refer to the rear-panel Ethernet connectors
only. See
Ethernet Gb
on page 93 for information on managing the on-
module Ethernet connector.
IQMIX25/40
User Manual
53