Setting Values; Information Display - GRASS VALLEY IQMIX25 Series User Manual

RollCall Control Panel

Information Display

Setting Values

Many of the settings within the templates have values, either alpha or numeric.
When setting a value in a field, the value, whether text or a number, must be set by pressing the
E
Clicking an associated
Information Display
The Information display pane appears at the top of each page, and shows basic information
on the input, standard and status of the module. The information to be displayed is defined on
the SDI Selection and Information Select panes to the right of the Information display.
34
• Receiver TPG (Test Pattern Generator) - see
• Counters - see page
• FEC (MIX25 only) - see
• NMOS - see page 48.
• Ethernet Pages 1 and 2 - see
• Ethernet 1 and 2 RTP Sender - see
• Ethernet 1 and 2 RTP Receiver - see
• Ethernet RTP Receiver Video Stats - see
• Ethernet RTP Receiver Audio Stats - see
• Ethernet RTP Receiver Meta Stats - see
• Link Control - see page
• HDR Control - see page
• Destination Timing - see
• Audio V Fade - see page
• Audio Type Control - see
• Input Loss Control - see
• Spigot 1-x - see page
• Logging - SDI Info - see
• Logging - System - see
• Logging - Network - see
• Logging SFP - see page
• Logging FPGA - see
• Logging Spigot 1-x - see
• Logging - NMOS - see
• Logging - Card Diagnostics - see
• Rolltrack - see page
• Loopback Router - see
• Setup - see page 91.
• Ethernet Gb - see page
• Ethernet Arcnet - see
• Interop - see page 94.
• SFP Configuration - see
key, or clicking the
NTER
45.
page 46.
page 53.
.
page 54
page 55
page
page
page
59.
60.
page 62.
63.
page 64.
page 65.
66.
page 72.
page 73.
page 77.
79.
page 82.
page 83.
page 86.
page 87.
88.
page 90.
93.
page 93.
page 96.
Save Value button.
Preset Value button returns the value to the factory default setting.
page 44.
.
56.
57.
58.