Seagull Models ANGEL GLIDER 2000 Assembly Manual page 12

Table of Contents

Advertisement

Angel 2000 Glider
Epoxy.
12
Instruction Manual.
BALANCING.
1) It is critical that your airplane be
balanced correctly. Improper balance will
cause your plane to lose control and
crash. THE CENTER OF GRAV-
ITY IS LOCATED 86MM BACK
FROM THE LEADING EDGE OF
THE WING AT THE WING ROOT.
2) Mount the wing to the fuselage. Using
a couple of pieces of masking tape, place
them on the bottom side of the wing
86mm back from the leading edge of the
wing at the wing root.
3) It should hang level when suspended
at the recommended balance point. Place
your fingers on the masking tape and
Accurately mark the balance point on
the botttom of the wing on both sides of
the fuselage. The balance point is located
86mm back from the leading edge of the
wing at the wing root. This is the bal-
ance point at which your model should
balance for your first flights. Later, you
may wish to experiment by shifting the
balance up to 10mm forward or back to
change the flying characteristics.

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500154

Table of Contents