Configuring Password; Figure 194 Maintenance > General Setup; Table 113 Maintenance > General Setup - ZyXEL Communications NBG410W3G User Manual

Chapter 20 Maintenance
Figure 194 MAINTENANCE > General Setup
The following table describes the labels in this screen.
Table 113 MAINTENANCE > General Setup
LABEL
General Setup
System Name
Domain Name
Administrator
Inactivity Timer
Apply
Reset

20.3 Configuring Password

Click MAINTENANCE > Password to open the following screen. Use this screen to change
the ZyXEL Device's management password.
326
DESCRIPTION
Choose a descriptive name for identification purposes. It is recommended you enter
your computer's "Computer name" in this field. This name can be up to 30
alphanumeric characters long. Spaces are not allowed, but dashes "-" and
underscores "_" are accepted.
The Domain Name entry is what is propagated to the DHCP clients on the LAN. If
you leave this blank, the domain name obtained by DHCP from the ISP is used.
While you must enter the host name (System Name), the domain name can be
assigned from the ZyXEL Device via DHCP.
Enter the domain name (if you know it) here. If you leave this field blank, the ISP
may assign a domain name via DHCP.
The domain name entered by you is given priority over the ISP assigned domain
name.
Type how many minutes a management session (via the web configurator) can be
left idle before the session times out. The default is 5 minutes. After it times out you
have to log in with your password again. Very long idle timeouts may have security
risks. A value of "0" means a management session never times out, no matter how
long it has been left idle (not recommended).
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
NBG410W3G Series User's Guide