Gastroback Easy Juicer Fun Operating Instructions Manual page 43

Note:
For selecting an appropriate speed, see: 'Properties of Your New »Easy Juicer
Fun«'.
IMPORTANT: The motor will start agitating immediately, when you touch the right
speed button . With the motor running, be aware that the appliance may move
around on the table or counter due to vibrations. Thus, ensure to keep the appliance
in an appropriate distance to the edge of the working space. After switching ON
the motor immediately fill in your food. You should NOT leave the motor operate
with empty feed chute for more than 1 minute.
Touch the right speed button
the LCD display and the working time display will start running. When touching the
right speed button
speed, touch the left speed button
of your new »Easy Juicer Fun«').
WARNING – Risk of Injuries:
ting on high speed at the bottom of the filter basket. Additionally, parts of your food
could splash out of the feed chute. Thus, during operation, DO NOT place your fin-
gers or any foreign objects into the feed chute. Do not hold your face over the feed
chute.
Take the pusher out of the feed chute and fill the prepared food into the feed chute.
However, at the maximum, fill the feed chute up to 2 cm beneath the brim, so you
can still insert the pusher. Use the pusher to push down the food only slightly.
Note:
Do not apply too much pressure onto the pusher, as this could decrease the quality
and amount of the juice and even cause the appliance to get blocked. The very
best method of processing is to drive the pusher slightly up and down repeatedly
until the feed chute is empty.
When the feed chute is empty, before processing the next portion, ensure that the
juice jug and pulp container can still absorb a sufficient amount of juice and pulp.
Do not fill the provided juice jug with more than 1000 ml (1 litre) to avoid
overflow. To empty the juice jug, simply take it out from under the juice out-
let. For this you may turn the protrusion on the drip-stop spout upwards to
avoid the spilling of juice. Ensure to turn the protrusion back down-
ward to open the drip-stop spout before juicing another portion of food.
To empty the pulp container, always switch OFF the appliance first (touch the ON/
OFF button twice until the ON/OFF button flashes), then unplug the appliance and
wait until the motor comes to a standstill. Disassemble the pulp container according to
the instructions in chapter 'Care and Cleaning' (see: 'Disassembling the Appliance').
After emptying juice jug and/or pulp container, ensure that you made the juicer
to switch ON the motor. Speed 1 will be shown on
again, the speed will be increased in steps. To decrease the
. Select the appropriate speed (see: 'Properties
During operation, very sharp blades are agita-
43