Assembling The Screw Sleeve; Assembling The Screw Cap With The Membrane Holder - KTM 450 SX-F EU Repair Manual

Ol/FORK, TRIPLE CLAMP
29
- Lubricate the special tool.
Fork oil (SAE 5) (-- p. 224)
Calibrating unit (Tl4021) (-- p. 238)
- Press the special tool through the new pilot bushing a number of times.
I
Calibrating unit (Tl4021) (-- p. 238)
, / The pilot bushing is calibrated.
Follow-up work
- Assemble the screw sleeve. (-- p. 29)
Assemblinl tIIa screw sleave
• Info
I
The steps are identical for both fork legs.
- Mount and lubricate O-ring.
I
Lubricant (Tl58) (-- p. 226)
- Mount ring .
- Mou nt lock ri ng
• Info
I
The seal ring is mounted when the piston rod is assembled.
20086&-11
Assembllnl tile screw caP. with the membrane holder
• Inlo
I
The steps are identical for both fork legs.
Preliminary work
- Check the fork legs. (-- p. 23)
Main work
- Lubricate and mount O-ring.
I
Lubricant (Tl58) (-- p. 226)
- Clamp the open end wrench in a vise. Position compression holder.
- Mount the compression shim stack with the smaller shims facing downward.
200873-10
- Grind compression piston on both sides on a surfacing plate using 1200 grit
sandpaper.
- Clean the compression piston.
- Mou nt and grease O-ri ng
I
Lubricant (Tl58) (-- p. 226)
- Mount the compression piston.
Guideline
View Compression piston from above
View Compression piston from below