KTM 450 SX-F EU Repair Manual page 35

Ol/FORK, TRIPLE CLAMP
201369-10
. _ (0
- Push the cartridge into the fork leg.
- Press the cartridge against the spring and mount special tool
I
Support tool (Tl4020) ( ... p. 238)
- Grease the O-ring of the rebound adjuster.
I
Lubricant (Tl58) ( ... p. 226)
- Mount the rebound adjuster.
, / The rebound adjuster must reach the stop before the piston rod turns with it.
In case of tight piston rod threads, it must be held to keep it from turning.
X
If the rebound adjuster is not turned all the way to the stop, the rebound
damping cannot be correctly adjusted.
- Hold onto nut and tighten the rebound adjuster.
Guideline
Rebound adjuster on the piston rod M12x1
- Press the cartridge against the spring and remove special tool
- Tighten the rebound adjuster.
Guideline
Rebound adjuster on the axle clamp M20xl
- Clamp in the fork vertically.
- Fill with fork oil.
30 Nm
(22.1 Ibf
tt)
30 Nm
(22.1 Ibf
tt)
Oil capacity fork 390ml Fork oil (SAE 5) ( ... p. 224)
leg without car- (13.19 fl. oz.)
tridge
- Lubricate O-ring of the cartridge.
I
Lubricant (Tl58) ( ... p. 226)
- Push the outer tube upward.
- Clamp the outer tube in the area of the lower triple clamp.
I
Clamping stand (Tl403S) ( ... p. 239)
- Tighten the cartridge.
Guideline
Cartridge on the outer tube M51x1.5
I
Ring wrench (Tl4017) ( ... p. 237)
50 Nm
(36.9 Ibf
tt)
- Mount adjuster of the compression damping. Mount and tighten the screw.
Guideline
Screw, compression adjuster M4xO.5 1.5Nm
(1.11 Ibf
tt)
35