Related Manuals for KTM 450 SX F EU 2010
Summary of Contents for KTM 450 SX F EU 2010
- Page 1 SETUP INSTRUCTIONS 2010 450 SX‑F EU 450 SX‑F NAGL EDITION EU 450 SX‑F USA Art. no. 3211581en...
- Page 3 KTM accepts no liability for delivery options, deviations from illustrations and descriptions, as well as misprints and other errors.
-
Page 4: Means Of Representation
MEANS OF REPRESENTATION Symbols used The symbols used are explained in the following. Indicates an expected reaction (e.g. of a work step or a function). Indicates an unexpected reaction (e.g. of a work step or a function). Identifies a page reference (more information is provided on the specified page). Formats used The typographical and other formats used are explained in the following. - Page 5 SET‑UP Unpacking and setting up the vehicle Packaging 2 – Remove the box and the plastic packaging. Info To avoid damaging the motorcycle during assembly, leave the protective film on the vehicle until you have finished. – Take out the separate enclosure and unpack it. Check its contents on the basis of the enclosure list.
- Page 6 SET‑UP (450 SX‑F EU, 450 SX‑F USA) 0 0 1 – Remove screws . Take off the handlebar clamps. – Remove screws . Take off the handlebar holders. 0 0 2 – Move the handle bar holders to the desired position. Mount and tighten screws ...
- Page 7 8) – Install the battery. ( p. 9) – Unpack the KTM PowerParts (optional) contained in the delivery and install them. Info Read the accompanying KTM PowerParts installation instructions. – Attach the stickers contained in the delivery (optional). –...
- Page 8 SET‑UP – Print out the current PDI form found on KTM DEALER.NET and perform the delivery inspection.
- Page 9 WORK Removing the seat – Remove screw . Lift up the seat at the rear, pull it back and then remove from above. 500080-10 Mounting the seat – Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear and simultaneously push it forward.
- Page 10 – Do not discard batteries with the household trash. Dispose of a defective battery in an environmentally compatible manner. Give the battery to your KTM dealer or to a recycling center that accepts used batteries. Warning Environmental hazard Hazardous substances cause environmental damage.
- Page 11 WORK – Mount the seat. ( p. 7) Installing the battery – Place the battery in the battery holder. ≥ 10 °C (≥ 50 °F) External temperature Battery (YTX4L-BS) ≤ 10 °C (≤ 50 °F) External temperature Battery (YTX5L-BS) – Reconnect the rubber band ...
- Page 12 WORK Closing filler cap 3.10 – Replace the filler cap and turn clockwise until the release button locks in place. Info Route the fuel tank breather hose without kinking. 400199-11 Refueling 3.11 Danger Fire hazard Fuel is highly flammable. –...
-
Page 13: Technical Data - Tightening Torques For Chassis
TECHNICAL DATA - TIGHTENING TORQUES FOR CHASSIS – Spoke nipple, front wheel M4.5 5… 6 Nm (3.7… 4.4 lbf ft) – Spoke nipple, rear wheel 5… 6 Nm (3.7… 4.4 lbf ft) – Remaining nuts, chassis 15 Nm (11.1 lbf ft) –... - Page 14 SUBSTANCES Super unleaded (ROZ 95 / RON 95 / PON 91) According to – DIN EN 228 (ROZ 95 / RON 95 / PON 91)
-
Page 15: Auxiliary Substances
AUXILIARY SUBSTANCES Long-life grease Guideline – ® KTM recommends Motorex products. Supplier ® Motorex – Fett 2000... - Page 16 *3211581en* 3211581en KTM-Sportmotorcycle AG 5230 Mattighofen/Austria http://www.ktm.com...
Need help?
Do you have a question about the 450 SX F EU 2010 and is the answer not in the manual?
Questions and answers