Agilent Technologies 280-DS Operator's Manual page 48

4 Operating the 280-DS
Instrument Module Position on the Vessel Plate
If a vessel plate level test is required, the software prompts you to place the
280-DS Instrument Module (IM) on the vessel plate as shown in the figure below.
1 Position the IM on the vessel plate in an appropriate location.
2 Click Run to start data collection.
Figure 26.
NOTE
48
IM Position on Vessel Plate
The AS FOUND values displayed on the lower left of the screen will
be recorded on the test report when you click Run. This data is
updated in real time.
280-DS Operator's Manual