Indication Of The Instantaneous Consumption Values; Indication Of The Cause Of Switching-Off; Holiday Mode - Conel CLEAR 2.0 SAFE Operating Instructions Manual

42
6.7
INDICATION OF THE INSTANTANEOUS CONSUMP-
TION VALUES
In addition to the set limit values, the LED rows indicate at half luminosity the instantaneous measured val-
ue when water is being drawn. The instantaneous water flow, the volume of water that has already been
drawn and the duration of drawing of water are thus easily read off.
6.8

INDICATION OF THE CAUSE OF SWITCHING-OFF

If one of the set limit values is reached, the shut-off valve closes.
The LEDs which were equal to or less than the set limit value, then flash and in this way indicate the cause
of switching-off.
Moreover the red "Closed" LED indicates that the shut-off valve is closed. Brief pressing of the manual
pushbutton reopens the isolation valve and switches off the flashing of the LED row.
6.9

HOLIDAY MODE

If no water is used for a duration of 72 h (e.g. absence due to holiday), the control sensor can switch to so-
called "Holiday mode". Prerequisite for this is that for DIP switch S4, contact 1 is switched to the left in po-
sition "ON". Using contacts 2 to 4, different holiday mode limit values can be set for the control sensor:
DIP switch S4
Holiday mode
Max. water flow
Max. water volume
Max. time duration
DIP switch S4
After the control sensor has switched to holiday mode, the yellow "Holiday" LED illuminates. The resultant
changed limit values are indicated by the LED rows.
Holiday mode is exited by brief pressing of the manual pushbutton. The yellow "Holiday" LED switches off
and the LED rows indicated the limit values set using DIP switch S1 to S3.
After 72 h without water consumption: "On"
0.5 m³/h
50 l
6 min
1 m³/h Control sensor
closed (after 72 h
100 l
without water con-
12 min sumption)
"Off"
(Limit values
set using S1, S2, S3)