Series Connection Of The Sensor St4-A - Panasonic ST4 Instruction Manual

Before Using this Device
Connecting the single-beam sensor with the controller:
Procedure
1. Insert the male connector of the ST4-A□ in connector of the controller.
2. Turn the fixing ring to tighten.
Fixing ring
Disconnecting
Procedure
1. Loosen the fixing ring.
2. Pull out the connector by holding the fixing ring.
Fixing ring
CAUTION
•
Before removing the connectors, make sure that the fixing rings are fully
loosened.
• If the connectors are forcibly pulled out with the fixing rings tightened, the
connectors may be damaged.

2.4.4 Series Connection of the Sensor ST4-A□

You can connect up to six units of the ST4-A□ per controller in series.
When connecting several sensors, the extension cable ST4-CCJ□ (optional) and the branch
cable ST4-CCJ05-WY (optional) are needed. Please purchase them separately.
32
SEN TRONIC
AG
Produkte, Support und Service
Emitter connector of the controller
Receiver connector of the controller
Connector of
Rugghölzli 2 Tel. +41 (0)56 222 38 18
CH - 5453 Busslingen Fax +41 (0)56 222 10 12
Panasonic ST4 Instruction Manual
ST4-A□
mailbox@sentronic.com
www.sentronic.com