Panasonic ST4 Instruction Manual
2.4 Mounting and Removing
2.4.1 Mounting and Removing the Controller
The controller can be mounted on a 35mm width DIN rail.
Procedure
1. Push the DIN rail stopper.
2. Fit the tab on the opposite side of the DIN rail stopper onto the DIN rail.
3. Press the device into place.
Remove the controller.
Procedure
1. Insert a flathead screwdriver into the groove of the DIN rail stopper and pull
out the stopper.
2. Push the controller in the opposite direction.
3. Lift and remove the controller.
2
CAUTION
Removing the controller without unlocking the DIN rail stopper may cause the
tabs to break.
SEN TRONIC
AG
Produkte, Support und Service
DIN rail stopper
1
3
2
35mm width DIN rail
1
3
1
Rugghölzli 2
CH - 5453 Busslingen
2.4 Mounting and Removing
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
29
mailbox@sentronic.com
www.sentronic.com