Before Using this Device
2.1 Features
This device is a safety beam sensor with the following features.
•
The controller ST4-C11 or the multifunctional controller ST4-C12EX is used in
combination with the single-beam sensor ST4-A□.
•
The type ST4-A□V comes with an emission amount adjuster to reduce the emission
amount.
•
Up to six units of the ST4-A□ can be connected per controller. The controller has an
automatic interference prevention function.
•
Wiring can be easily done by using the extension cable ST4-CCJ□ (optional) and the
branch cable ST4-CCJ05-WY (optional), since the cables are connector types
•
The control output (OSSD 1/2) is a PNP/NPN output switching type. The output type
can be switched with the output polarity selection switch on the controller.
•
Replacing the relay is not necessary since a semiconductor output is used.
•
The muting function complying with ISO 12643 (safety requirements for graphic
technology equipment and systems) is available on the ST4-C12EX. For details, refer to
the Muting Function (see page 59).
8
SEN TRONIC
AG
Produkte, Support und Service
Rugghölzli 2
Tel. +41 (0)56 222 38 18
CH - 5453 Busslingen
Fax +41 (0)56 222 10 12
Panasonic ST4 Instruction Manual
mailbox@sentronic.com
.
www.sentronic.com