Status Leds - Johnson Controls P2000 Hardware Installation

CKM-MR16OUT
24-10707-82 Rev. D
S8 S7 S6
OFF OFF
OFF ON
ON OFF
ON ON
OFF
ON
1. Firmware revisions prior to 1.38.1, this setting is 2,400 BPS.
2. Firmware revisions prior to 1.38.1, SW8 is not defined. Set to the OFF position.
S LED
TATUS S
Process LED Information
Power-up All LEDs OFF
Initialization Once you apply power, initialization of the module begins.
When initialization is completed, LEDs A, B, CT, and BA are briefly
sequenced ON then OFF.
Running A LED Heartbeat and On-Line Status:
Offline
1-second rate, 20% ON
Online
Non-encrypted communication: 1-second rate, 80% ON
Encrypted communication:
Table 2: Switches
S5 S4 S3 S2
ON ON ON OFF ON
ON ON ON ON
ON ON ON ON
Table 3: LED Information
0.1 second ON
0.1 second OFF
0.1 second ON
0.1 second OFF
0.1 second ON
0.1 second OFF
0.1 second ON
0.3 second OFF
Hardware Installation Manual
S1 Selection
Address 29
OFF Address 30
ON Address 31
115,200 BPS
9,600 BPS
19200 BPS
38,400 BPS
Encrypted communication not
2
required
Encrypted communication
2
required
7
1