Quick Start Instructions; Step 1: Installing The Software - Zoom Gateway/Router V3 User Manual

1.2 Quick Start Instructions

Installing the V3 involves five steps: Installing the Software,
Installing the Hardware, Configuring Internet Explorer,
Configuring Your V3, and Setting Up VoIP Service.

Step 1: Installing the Software

Installing the software is only required for people connecting a
Windows computer directly to the V3. All others should skip to
Step 2: Installing the Hardware.
If your computer has an available Ethernet jack, we recommend
that you use it instead of the USB jack. This will simplify
installation.
If you decide to use the V3's USB jack, you must remove any
previously installed USB modem drivers on your computer
before installing this software. On the desktop, click the Start
button, point to Settings, and select Control Panel. In Control
Panel, double-click Add/Remove Programs, on the
Install/Uninstall tab, select your old USB modem from the list,
and click Remove. Now continue below.
1 1 1 1
Your computer must be on. Insert the supplied CD into
your computer's CD drive. The CD should start automatically
and the Select Language screen should appear. (If the CD
does not start automatically, on the desktop, click the Start
button, click Run, and then type D:\setup.exe, where D is
the letter of your CD drive.)
2 2 2 2
Select your language and click the Installation Wizard
button. The software installation proceeds automatically.
3 3 3 3
When the process is complete, you will be prompted to click
Finish and then Shut Down to turn off your computer.
Remove the CD from your CD drive before you shut down
your computer.
8 Zoom V3 User's Guide