Zoom Gateway/Router V3 User Manual page 11

Powering Up
To ensure that all the devices you just connected to the V3 install
correctly, you need to power up each device one at a time. Follow
these steps carefully.
1 1 1 1
Plug in the modem's Power Supply, and turn on the
modem's on/off switch if it has one.
Plug the modem's power cube into a power outlet.
Wait for one-two minutes so that you are sure the modem has
completed its power up process before proceeding to Step 2.
2 2 2 2
Plug in the V3's Power Supply.
Plug the included power cube into a power outlet and then
into the V3's power (PWR) jack.
Wait for one-two minutes so that you are sure the V3 has
completed its power up process before proceeding to Step 3.
Note: Use only the power cube shipped with the V3 or you
may cause damage to your hardware.
3 3 3 3
Turn the computer on.
If you are using USB, a Found New Hardware box should
display, showing the progress of the installation. Follow the
prompts.
—Windows XP users: You may see Hardware Installation
disclaimer boxes regarding Windows logo testing. You can
safely disregard these messages and click Continue Anyway.
—Windows 2000 users: You may see a Digital Signature
Not Found dialog box. You can safely disregard this message
and click Yes.
—Windows 98/Me users: Restart your computer if you are
prompted to do so.
Chapter 1: Installation Instructions 11