Kioti NX4510 Manual page 211

(1) Drain plug
3. To drain the used fluid, place the oil
pan under the transmission case
and turn the drain plug counterclock-
wise to drain the fluid completely.
If the fluid does not flow out freely,
unscrew the plug on the side of the
hydraulic cylinder on the left of the
top link bracket to facilitate drain-
age. (ref to next page)
4. unscrew the fluid filter from the
rear right section on the tractor us-
ing a filter wrench.
TE120(NX4510,5010,5510)CABIN,ROP19 19
TE1O710B
(1) oil filler plug & gauge
(a) oil level is acceptable within this range
5. Apply a thin film of clean oil onto
the O-ring of a new filter.
6. tighten the filter firmly until it
contacts the mounting surface.
Tighten the filter a half turn further
by hand.
7. run the engine for a few minutes
and then stop it after installing a
new filter.
8. Check the fluid level and add fluid
to the specified level.
Model
manual 17.2 u.s.gal. (65 l)
hst 14.6 u.s.gal. (55 l)
9. make sure that the transmission
fluid does not leak through the seal.
caUtiOn
to avoid personal injury:
•
Be sure to stop the engine
TE1O703B
before changing the fluid or
replacing the filter.
•
Cool down the fluid sufficient-
ly. you can get burnt by hot
fluid.
iMPORtant
•
to prevent serious damage to
the hydraulic system, use only
a KIOTI genuine filter.
•
Do not operate the tractor im-
mediately after changing the
transmission fluid. Run the
engine at medium speed for a
few minutes to prevent dam-
age to the transmission.
7 7
maintenance maintenance 1 1
- -
Oil capacity
7
2016-04-25 오후 5:49:53