Kioti NX4510 Manual page 152

5
 Nx4510/Nx5010/Nx5510/Nx6010
-
OPERATING.PRINCIPlE.Of.PRE-
HEAT.SySTEm
The glow plug lamp comes on for 8
seconds and then goes off when the
key switch is turned to the "oN" posi-
tion.
The engine should be started within
5 seconds after the glow plug lamp
goes off. After the engine is started,
post-heat is performed for 15 sec-
onds with the key switch in the "oN"
position.
The preheat/after-heat function and
glow plug lamp do not operate when
the coolant temperature is 30°c (86°
f) or higher. In this case, the engine
can be started without the preheat
operation.
* The post-heating is a function to
keep the preheating function acti-
vated for approx. 15 seconds after
the engine is started in order to
enhance the engine combustion
performance and reduce harmful
emissions right after engine start.
TE120(NX4510,5010,5510)CABIN,ROP8 8
WARNING
Never. operate. the. start. motor.

for.10.consecutive.seconds.as.
it. consumes. a. lot. of. power.. If.
the. engine. cannot. be. started.
within. 10. seconds,. wait. for. 30.
seconds.and.try.again..
When.trying.to.start.the.engine.

again,. make. sure. that. the. fly-
wheel.is.stopped.in.advance.
9. When the engine is started, re-
lease the key. Then, the key is
automatically turned back to the
"oN" position.
WARNING
Do. not. turn. the. key. switch. to.

the. "Start". position. while. the.
engine.is.running.
10. Warm up the engine for 3 to 4
minutes (10 minutes in winter)
after releasing the clutch pedal.
(1) Instrument panel
(2) Engine oil pressure Warning lamp
(3) charge Warning lamp
11. check to see that all the warning
lamps on the instrument cluster
turn "off". If any lamp remains
on, immediately stop the engine
and determine the cause.
TE1O502B
2013-11-05 오후 4:11:43