Cabinet Trims Installation - [A] Flexible Spring Clip Method - Fisher & Paykel ACTIVESMART RS36A80 Installation Manual

[B] FIXED SCREW METHOD — METHOD TO USE IF CABINET IS NOT TO SPECIFICATION
(Attempt method [A]. If method [A] results in poor fitment of side trims due to cabinetry that is uneven or out of specification, use method [B]).
Internal box
Break off the datum lip to each side trim bracket and discard.
1
Repeat for all side trim brackets.
Cabinet side
D
trim install kit
Side trim bracket
(6)
Spring clip
(6)
External box
For 80 (2032mm) cavity installation only
Cabinet side trim
(2)
Measure 4" (102mm) from the top of
2
the side trim with a square ruler and mark
a cutting line (A).
Tools
Cut along the line using a fine tooth
3
hacksaw to a length of 76" (1930mm) (B).
IMPORTANT!
Ensure the cut is straight and square
●
as this is an exposed surface.
Ensure the plastic part does not bend
●
Hacksaw
as this can cause visual stress marks.
Repeat for all side trims.
Pencil
38
TWO METHODS ARE AVAILABLE FOR ATTACHING CABINET SIDE TRIMS:
[A] FLEXIBLE SPRING CLIP METHOD — RECOMMENDED METHOD
CABINET TRIMS INSTALLATION — [A] FLEXIBLE SPRING CLIP METHOD
Discard
Aluminum
4
A
B
Plastic
Side trim
bracket
short lip
Place 3 side trim brackets onto
each side trim.
Note: Measure from the top of the
trim, with the short lip at the bottom.
Refer to (B) for 80" and 84" bracket
locations and trim orientation.
IMPORTANT!
Each bracket has two engagement
points for the side trim to locate.
Ensure the trim is engaged in both
points (C).
Repeat for all side trims.
Side trim
C
Top view of side trim engaged
correctly in side trim bracket
0
80 = 9" (229mm)
84 = 13" (330mm)
80 = 36" (914mm)
84 = 40" (1016mm)
80 = 65" (1651mm)
84 = 69" (1753mm)
short lip
B