Fisher & Paykel ACTIVESMART RS36A80 Installation Manual page 28

IMPORTANT!
Door panel
B
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
●
attachment
kit
Adjust the door panels
8x16 mush washer
Place a ruler on the front of the appliance to check
1
(Custom) screw (2)
flushness top and bottom, left and right.
– Ensure the gap between the top of the door panel
Tools
– To reduce this gap, raise the appliance by turning all
FPA spanner
#8 x 16
Mush Washer
Twin Thread
Philips Screw
Hex key
Cross-head screwdriver
Ruler
26
DOOR PANEL INSTALLATION - STAINLESS STEEL
and the top cabinetry is not more than 1/4" (7mm).
four adjustment nuts the same number of turns.
A
Each door panel has full axis adjustment to ensure
2
flushness with adjacent walls. To adjust the height of
the panel, turn the stud clockwise to raise or counter-
clockwise to lower the door panel (A).
Once satisfied with the alignment, secure M8 studs with
3
M8 washer and M8 nut (B). The top of the stud must
remain below the top face of the door panel.
Secure side bracket forks by
4
tightening side screws (C).
Repeat for all door panels.
Note:
– For depth adjustment,
loosen the side screws (10),
adjust the panels and then
retighten once satisfied.
– Further adjustment of door
panels can be achieved by
removing door panels then
loosening the fixing screws
for the hanging bracket and
moving the bracket sideways
to suit.
Loosen the M8 stud (D) so that
5
locking bracket can slide freely
back to front.
– Slide the locking bracket out until it touches the
back of the door panel. Fully tighten the M8 stud.
– Screw in place using a #8x16 screw through one
of the three slotted holes.
B
C
D