IMPORTANT!
Ice and Water display
(Ice and Water
Failure to follow these steps can lead to difficulties in door panel adjustment and cosmetic cap fitment.
●
models only)
For water dispensing door panels: Remove the protective film from the appliance doors before hanging door panels.
●
Connect the external display module (for Ice and Water models only)
External display module
(1)
Remove the external display module
1
taped to the front of the appliance.
Thread the display harness through
2
the door panel cavity (A).
– Ensure the grommet is engaged.
Turn the top display tabs at an angle
3
into the door panel (B).
– Ensure the harness is free
Push firmly against the bottom
4
display tabs and insert into the door
panel until you feel it clip securely.
– Ensure the display is flush
Remove water tube from the
5
holder on the appliance door (C).
Hang the door panel onto
6
M8 studs.
– Ensure the panel is free to
24
DOOR PANEL INSTALLATION - STAINLESS STEEL
of pinching.
with the door panel.
pivot for water connections.
C
Connect the display harness onto the
7
appliance door by inserting firmly until you
A
feel it clip securely (D).
– On the external display, enable the
dispenser lock to prevent any water
from dispensing during water connection.
– To lock, press the
4 seconds. The LED above the
button will illuminate.
B
Push the water tube firmly into the spigot
8
behind the door panel until the marked line
is not visible (E).
– Ensure the water tube is routed away
from any sharp objects or corners, and
not in a location where it can be kinked
or squashed when the door panel is
secured, (as this will stop water flow).
button for
D
E