Water And Power Supply Connection - Fisher & Paykel ACTIVESMART RS36A80 Installation Manual

IMPORTANT!
Water fittings kit
(Ice and Water
Ensure that the water connection is performed by a professional installer.
●
models only)
The standard appliance includes a braided water line hose compatible
●
with a brass adaptor.
Ensure there is enough tubing for the water connection and to pull
●
the appliance out for service, if required.
Collet locking clip
(1)
Connect to water
(for Ice and Water models only)
1/4" (6mm) Stainless Move the appliance in front of the
1
steel braided hose with
cabinetry close enough to allow access
adaptor (1)
behind for power and water connections.
At the front of the appliance, insert the
2
adaptor of the braided water line hose
(A) into the PRV.
Note: If using a 1/4 PEX plastic tubing,
you need to use a water fittings kit (not
supplied and must purchase separately).
Insert the tube end of the adaptor fully
3
into the PRV. Once inserted, pull gently
on the tubing to ensure it is locked in (B).
Note: Dislodge the PRV from the clips,
if required.
Secure the connection by inserting a
4
locking key between the PRV and tube
end of the adaptor (C).
– If the PRV is dislodged during
Thread the free end of the water line hose
5
into the hole located at the base and
through the back of the appliance (D).
18

WATER AND POWER SUPPLY CONNECTION

installation, mount the PRV back
into the clip.
Flush water through the hose prior to connection to the appliance
●
to remove any debris in the hose.
We recommend to use an isolating switch that can be accessed
●
easily after the appliance is installed.
A
PRV
braided
hose with
adaptor
B
D
C
F
At the back of the appliance, connect the free end
6
of the braided hose to the water supply (E), and
then loosely coil the water line hose (~2 – 3 times).
– Do not over-tighten the connection.
– Turn ON the water supply and check that all
connections are dry and free of drips.
Connect to power supply
Locate the power cord and connect the fitted
7
plug to the electrical supply (115VAC, 60Hz) (F).
Turn ON the appliance to test if working.
– If using an isolating switch, turn OFF the
appliance before continuing the installation.
E