Advertisement
areas. When such conditions exist, frequent
washing and waxing are necessary. GM Chrome
Cleaner is an excellent material for cleaning the
chrome on your car.
Anodized Aluminum Parts-ClOstic cleaning
agents will discolor anodized aluminum parts
such as exterior trim. 00 not permit the use of
steam or cleaning solutJom containing these
agents for the cleaning of your car.
Vinyl Covered Rool-To wash the vinyl covered
roof, use lukewarm water and suds from a
neutral soap. A cloth or soft·bristled brush is
recommended for applying the solution of suds.
Deeply embedded dirt can be removed with e
nylon bristled brush and a smell amount of
foaming type cleanser. All traces of the cleanser
should be removed with clean water. Do NOT
use volatile cleaners, naphtha, gasoline, harsh
household cleaners and detergents, or bleaching
agents. A wire brush will
seriou~y
damage the
vinyl roof material, and should not be used.
Care 01 Convertible Top and Rear Window-The
convertible top should never be subjected to
volatile cleaners or household bleaches. Frequent
washing with neutral soap suds, tukewarm water
and a soft bristle brush is normally all that
IS
necessary to maintain the "'ike
new"
look. In
the event heavy soilage or stubborn stains are
encountered, a mild foaming cleanser, lukewarm
water and a soft bristle brush may b. used. II
desired, the top may be supported Irom the
underside during the cleaning operation. Regard-
less
of which cleaning method is used, a generous
amount of rinse water
is
to be used, as any soap
that may have run down on the body finish may
cause streaks if allowed to dry.
After cleaning the top, be certain the top is
thoroughly dry before it is lowered.
The rear window in the back curtain may be
cleaned in the same manner as all body glass.
Volatile cleaning agents should be .. aided as
these liquids could have a deteriorating effect il
spilled on the convertible top material or any
painl1d finish.
Outside Mirrors-When cleaning the outside rear
view mirror, use
I
soh cloth and a mild detergent
or ammomated cleaning solution. For removal of
ICe, use a d",eer (spray type, blower type, etc.).
Scraping of "e from the mirror face could cause
permanent damage.
Special notes
Undercoating-Undercoating should not be
applied to any moving or rotating part. It should
be kept off air conditioner fittings, body drain-
holes, axhaust system, propaller shaft, compo·
nent vents and air filters. On cars equipped with
Automatic level Control, particular care should
be taken not to undercoat any fittings, lines, or
system components.
Advertisement
